Charm++ parallel programming system

[Abhinav Bhatele <bhatele AT illinoisalumni.org>]

Laercio,

Did you figure out this issue? The version of charm you were using earlier, was that a released version? You might have to recompile charm with --incdir --basedir and point to your charm installation.


- Abhinav

On Thu, Aug 4, 2011 at 8:12 AM, Laércio Lima Pilla <llpilla AT inf.ufrgs.br> wrote:

Hi,

I am compiling the latest version of charm ( git clone git://charm.cs.uiuc.edu/charm.git ) for some load balancing experiments.

After compiling charm, I add ScotchLB on Makefile_lb.sh, run it, run make depends and make charm++. These are the same steps that I've doing for some time, and my scripts were working correctly before.

I get the following error when running make charm++:

make: *** No rule to make target `scotch.h', needed by `ScotchLB.o'.  Stop.

Do you have any idea of what is happening?

Best regards,

Laércio LIMA PILLA

PhD Student at Federal University of Rio Grande do Sul (UFRGS)
Email: laercio.pilla AT inf.ufrgs.br or laercio.lima.pilla AT gmail.com 
Tel: +55 54 9973 6313
Website: www.inf.ufrgs.br/~llpilla

_______________________________________________
charm mailing list
charm AT cs.uiuc.edu
http://lists.cs.uiuc.edu/mailman/listinfo/charm

_______________________________________________
ppl mailing list
ppl AT cs.uiuc.edu
http://lists.cs.uiuc.edu/mailman/listinfo/ppl

-- 
Abhinav Bhatele
Postdoctoral Research Staff Member
Center for Applied Scientific Computing
Lawrence Livermore National Laboratory